Alesis ADAT-M20 Betriebsanweisung PDF herunterladen (Seite 52)

ADAT Bridge I/O48

Hardware Setup

The following sample setup allows

Pro Tools to act as the positional and clock

(transport) master using MMC and Word

Clock, using a Mark of the Unicorn Digital

TimePiece™ (DTP).

To connect this setup:

1 Connect the DTP to the ADAT by attach-

ing 9-pin sync cables between these devices

as shown in the illustration above.

2 Connect the DTP to your computer’s mo-

dem or printer port via serial cable as

shown in the illustration.

3 Connect Word Clock Out from the ADAT

Bridge to the Word 1x In port on the DTP.

DTP Settings:

◆ Timebase Source set to Word 1x and

MTC.

Software Conﬁguration

The DTP has the ability to translate the

ADAT-proprietary ABS time reference sig-

nal embedded on ADAT tapes into MIDI

Time Code. This enables you to synchro-

nize the ADAT and Pro Tools with near-

sample accuracy.

The DTP allows you to either control the

Pro Tools transport via the ADAT, or con-

trol the ADAT’s transport via Pro Tools. In

either case, Pro Tools should provide the

master clock reference signal.

Recording Tracks from ADAT to

Pro Tools with a DTP

This setup explains how to perform a syn-

chronized ADAT-to-Pro Tools track trans-

fer. Pro Tools functions as both transport

and clock master.

To transfer audio from ADAT to Pro Tools:

1 Connect the DTP to your system.

Conﬁguring the DTP in OMS Setup

(Macintosh Only)

2 In OMS Setup, create an OMS device for

the DTP if you haven’t already done so.

3 In OMS’ MIDI Device Info dialog, enable

send and receive MTC for the DTP.

4 In the OMS Setup window, connect the

DTP to the appropriate MIDI port.

5 Save the DTP conﬁguration document as

your current OMS setup.

On the DTP:

6 Press the source button until both the

MTC and Word 1x LEDs are lit.

7 Press the format button and choose the

desired frame rate.

Conﬁguring the DTP in OMS

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare