Alesis ADAT-M20 Betriebsanweisung PDF herunterladen (Seite 31)

Chapter 3: Using Your System 27

OMS Example Setup

(Macintosh Only)

If you are using a Macintosh with a MIDI

interface, BRC, JL Cooper DataSync2, or an

Opcode Studio 64XTC, you must configure

these devices in OMS so that they can com-

municate properly with Pro Tools.

OMS is installed on your computer as part

of the standard Pro Tools installation. For

detailed instructions on installing and con-

figuring OMS, refer to the Pro Tools System

Installation Guide.

If you are not using a MIDI interface, BRC,

or synchronization peripheral with your

Pro Tools/ADAT system, you can skip this

section.

▲ The directions given here explain how to add

a MIDI device to OMS. This setup assumes

you have already conﬁgured your MIDI inter-

face, if you are using one. You must conﬁgure

the MIDI interface before conﬁguring any OMS

devices.

To conﬁgure an OMS device:

1 Make sure that the peripheral and/or

MIDI interface is turned on and connected

properly to your system.

2 Launch Pro Tools.

3 From the Pro Tools Setups menu, choose

the OMS MIDI Setup command. The OMS

MIDI Setup dialog appears, allowing you to

select the serial port(s) that your MIDI in-

terface is connected to. After you have cho-

sen the desired port(s), click OK.

4 Launch the OMS Setup application.

5 Choose Studio > New Device.

6 In the MIDI Device Info window, choose

the Manufacturer and Model names for

your device (if available) and name the de-

vice using the Name ﬁeld.

7 Uncheck both Is Controller and Is Multi-

timbral.

8 Check both Receives and Sends MIDI

Time Code.

9 Click OK to close the MIDI Device Info

window, and save this document as your

current OMS Setup document.

OMS MIDI Setup dialog

Deﬁning an OMS MIDI device

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare