Alesis QS8.1 Bedienungsanleitung PDF herunterladen (Seite 31)

First Session: Part 3

QS7.1/QS8.1 Reference Manual 29

PART 3

FIRST SESSION

POWERING UP

Once your QS7.1/QS8.1 is connected to an audio system of some kind, you are ready

to play. Here’s how to begin.

1) Make sure that all connections have been made correctly, and that the volume

controls in your amplification system and QS are set to zero.

2) Throw the QS’s rear-panel [ON/OFF] switch to ON (the up position). The

display should light up and look something like this:

If this isn’t the first time your QS has been used, it may not say PROG in the

bottom left of the display. Press the [PROGRAM] button once to change that.

3) Push the [VOLUME] slider all the way up.

4) Turn on your amplifier or mixer, and gradually raise its volume while playing

your QS. When the sound is as loud as you want, stop.

PLAYING THE DEMO SEQUENCES

The QS has five built-in sequences designed to demonstrate its rich variety of

sounds and signal-processing effects. To hear these at their best, make sure to run

your QS in stereo (or else listen on headphones).

Please note: Your QS doesn’t send out MIDI messages during demo playback. In

addition, the keyboard is disabled. You can listen to the demos, but you can’t play

along with them.

• To play all five sequences in order, hold down the [MIX] button and press [0].

When all five have played, your QS will exit DEMO mode on its own.

• To stop the demos at any point during playback, press [MIX] again.

• To play a specific demo, hold down [MIX] and press any of the five number

buttons from [0] through [4]. After a brief pause playback will start with the

demo you’ve selected, then continue through the remaining demos until done.

Note: After any of the demos stop playing, the QS will automatically return itself

to Program Mode. The next time you enter Mix Mode you will probably see the name

of the demo which was last played. This is because the Mix which was used for the

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 187 188

Keine Kommentare

Alesis QS8.1 Bedienungsanleitung Seite 31